Step 1

Insert the 4 gray screws into the MCP fixing holes at the same time.

Step 2

Align the 4 gray screws with the screw holes of the stand, and twist each screw 2 to 3 turns.
Do not tighten individually.

Step 3

Pay attention to leaving a gap between the screw and the panel.
Overtightening will cause the panel to peel off the paint.

Step 4

Insert EFIS into the stand, aligning 2 rear fixing holes with the stand mounting holes.

NOTE: The front two holes are not available.

Step 5

Aligning the EFIS screw holes with the stand screw holes by keeping the screw holes of the MCP panel and the EFIS panel on the same plane.

Step 6

Screw in two self-tapping screws to secure the EFIS. Repeat from step 4 for another EFIS.

Step 7

Installation completed.